ok, i made a tune file, uploaded it to me ecm, said complete and now my truck will crank but wont start. whats the deal? i have the folllowing
90mm ford racing maf
44lb accel injectors
gt40 fuel pumps 300lph
intake and cat back
ecm code cux1
i used all these options, y wont it start?
wont start
Re: wont start
also on my multiloader utlility my stock file is NO LONGER in the 6 slot... so i opened it into #1 and re flashed my ecm by selecting the stock file from the folder and my truck STILL wont start... what is the deal?????
Re: wont start
i even try flashing the stock on back. my truck is DEAD. i am so pissed off right now. what is the deal? also one thing i noticed is while the key is on and the interface is plugged into the truck my fuel pumps are running non stop. is that normal? i ned to know how to get my truck running again. ive followed every instruction in the manual. i hope this didn't fry my ecm!
Re: wont start
Well found out what it is, my keys got erased from the pats system when i flashed the tune. now it's $150.00 to reprogram them, i wanna know is Sniper is gonna re-imbured me for this?!?!?!? i am very upset, I've never had this happen with any other programming tool. i followed directions to the "T" I flashed another tune trying to disable the pats system and the truck started up but the light still flashes, i'm not gonna drive it cause lord knows it will shut down on me.
Re: wont start
Sometimes after a reflash you need to disconnect the battery cable for a few minutes and PATS will work again. Everybody's programmers do this sometimes it is not isolated to Sniper. If you disabled PATS and it starts it won't shut down on you either. The only way you will need your PATS reprogrammed is if you changed the VIN number in your PCM which shouldn't happen either.
Matt R
Matt R
-
- General of the Army
- Posts: 427
- Joined: Fri Jul 20, 2007 2:53 pm