Page 1 of 1

96 Cobra question

Posted: Wed Oct 18, 2017 11:29 pm
by drakkhen_20
It's been a long time since I've messed with this stuff. Like over ten years. I've had a Cobra for two now. I was wondering can you tune for IMRC deletes in Special Forces ?

Re: 96 Cobra question

Posted: Thu Oct 19, 2017 9:37 am
by Sniper Chris
Depending on how old your tuning kit is, you may or may not be able to disable IMRC with Special Forces. I know the last two versions did allow for IMRC deletes but older versions did not.

Re: 96 Cobra question

Posted: Thu Oct 19, 2017 6:30 pm
by drakkhen_20
Ok how do I tell what I have ? Also I have windows 10 and some stuff doesn't work. So do I have to pay for an update or something?

Re: 96 Cobra question

Posted: Fri Oct 20, 2017 10:22 am
by Sniper Chris
To know what version you have there should be a small round decal on the interface box with a hand written number. If that's not there anymore then you would need to install the software and open it up. Once open you can go through the Special Forces questions to see if the IMRC question is there or not.
If you have an older version then as you mentioned, it may not work with Windows 10 (actually an issue with 64bit OS). If this is the case you can send the kit in to be updated. The charge for this is $100 plus shipping. However, keep in mind that the Recon has been discontinued (although it's still included) so it will not work with a 64bit OS.

Re: 96 Cobra question

Posted: Mon Oct 23, 2017 1:36 pm
by drakkhen_20
Ok, I'll check it out. I don't have it installed anymore and I have to find it. It's still in the original box somewhere. Been moving around a lot. What number am I wanted to find on that sticker ? I've seen it just never paid attention to it.

Re: 96 Cobra question

Posted: Tue Oct 24, 2017 10:03 am
by Sniper Chris
Should be version 19 or higher. It's possible that v14-15 may be ok too but I'm not 100% sure. We no longer have the older versions to our disposal so I'm not able to confirm that.