| It is currently Thu Sep 09, 2010 7:14 am |
|
All times are UTC - 5 hours [ DST ] |
recon problem
Moderators: cliffyk, sniperpat469
 
|
Page 1 of 1 |
[ 3 posts ] |
|
| Author | Message |
|---|---|
|
Private  Joined: Sun Apr 11, 2010 12:29 am Posts: 1 |
 recon problemwhile trying to connect pcm it says "unable to load DDL 'FTD2XX.ddl' The specified module could not be found. (Exception from HRESULT: 0x8007007E).
and once you click on details it says"See the end of this message for details on invoking just-in-time (JIT) debugging instead of this dialog box." followed by a whoooole mess of "exception text"...any ideas? |
| Sun Apr 11, 2010 12:38 am |
|
 |
|
|
Sniper Tech Support   Joined: Fri Sep 14, 2007 7:36 pm Posts: 725 |
Re: recon problem What firmware version is your interface box? There should be a round sticker on it, if not connect the interface to your PC and run Multiloader; the firmware version will be displayed in the lower right of the Multiloader dialog.
_________________ -cliff knight- My Mustang Multi-fuel: Burns gas and rubber |
| Sun Apr 11, 2010 5:34 pm |
|
|
|
|
General of the Army   Joined: Fri Jul 20, 2007 3:54 pm Posts: 1721 Location: Sanford, FL |
Re: recon problem It sounds like you haven't installed the drivers for the Interface. As Cliffyk asked, what version is your Interface/software?
_________________ Director of Sales & Marketing Technical Support 407.321.5725 www.DeltaForceTuning.com |
| Thu Apr 15, 2010 10:41 am |
|
|
|
|
|
Page 1 of 1 |
[ 3 posts ] |
|
All times are UTC - 5 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 1 guest |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |