Page 1 of 1

MAF transfer function

Posted: Wed Jul 19, 2017 2:53 pm
by Rich A
I have an 80mm MAF sensor from a MKVIII, but I manual loaded the 80mm lightning MAF Transfer Function.
When I input some of the Air Flow KG/HR they sometimes change to something else.
For example, lets say I put in 2.00v - 127.49, it changes it to 2.00v - 126.50.
Is this Normal :?

Re: MAF transfer function

Posted: Thu Jul 20, 2017 9:47 am
by Sniper Chris
The Lightning 80mm MAF xfer is different than the Mark VIII. I've attached a screen shot of the Mark VIII MAF xfer.
The numbers not being exactly what you're inputing is normal with our software. There's nothing to worry about if the kg/hr is off a few values. However if you insist on having the exact number then you will need to input a slightly higher (or lower) value than you're wanting.
98 Mark VIII MAF xfer.jpg
98 Mark VIII MAF xfer.jpg (107.8 KiB) Viewed 1294 times