MAF transfer function

New to tuning? Not sure where to start?
Post Reply
Rich A
Posts: 34
Joined: Thu Jul 16, 2015 7:25 pm

MAF transfer function

Post by Rich A » Wed Jul 19, 2017 2:53 pm

I have an 80mm MAF sensor from a MKVIII, but I manual loaded the 80mm lightning MAF Transfer Function.
When I input some of the Air Flow KG/HR they sometimes change to something else.
For example, lets say I put in 2.00v - 127.49, it changes it to 2.00v - 126.50.
Is this Normal :?

User avatar
Sniper Chris
General of the Army
General of the Army
Posts: 633
Joined: Fri Jul 20, 2007 3:54 pm
Location: Sanford, FL

Re: MAF transfer function

Post by Sniper Chris » Thu Jul 20, 2017 9:47 am

The Lightning 80mm MAF xfer is different than the Mark VIII. I've attached a screen shot of the Mark VIII MAF xfer.
The numbers not being exactly what you're inputing is normal with our software. There's nothing to worry about if the kg/hr is off a few values. However if you insist on having the exact number then you will need to input a slightly higher (or lower) value than you're wanting.
98 Mark VIII MAF xfer.jpg
98 Mark VIII MAF xfer.jpg (107.8 KiB) Viewed 2609 times
Director of Sales & Marketing
Technical Support


Post Reply

Return to “Commando - Delta Forces Getting Started”